How to sharpen a kitchen knife, and when to just hone it
The difference between honing and sharpening, how to use a whetstone step by step, how often to do each, and how to tell when a knife is dull.
A sharp knife is safer than a dull one. It goes where you aim it, takes less force, and doesn’t skid off an onion toward your fingers. Keeping one sharp is two separate jobs, and most people only know about one of them.
Honing versus sharpening
Honing straightens the edge. With use, the very thin edge of a blade bends and rolls over at a microscopic level, so it feels dull even though the metal is still there. A few strokes on a honing steel push it back into line. Hone every few uses.
Sharpening removes metal to make a new edge. You need it when honing no longer brings the knife back, usually once or twice a year for a home cook.
How to tell if a knife is dull
Hold a sheet of printer paper by one corner and slice down through it. A sharp knife cuts cleanly with almost no pressure. A dull one snags or tears. You can also try slicing a ripe tomato: a sharp knife breaks the skin with its own weight.
How to hone
- Hold the steel vertically, tip down on a cutting board.
- Place the heel of the knife against the top of the steel at about a 15 to 20 degree angle.
- Draw the knife down and toward you, so the whole edge from heel to tip touches the steel.
- Repeat on the other side. Five or six strokes per side, alternating, is plenty.
Slow and light beats fast and hard.
How to sharpen on a whetstone
A whetstone is a flat block of abrasive stone. A combination stone with a coarser side (around 1000 grit) and a finer side (3000 to 6000 grit) covers almost everything.
- Soak or wet the stone according to its instructions, and set it on a damp towel so it doesn’t slide.
- Find the angle. Most Western kitchen knives are sharpened at about 15 to 20 degrees. Rest the blade flat on the stone, then lift the spine until the gap is roughly the height of two stacked coins.
- Sharpen one side on the coarse side of the stone, pushing the edge across the stone in smooth strokes, working from heel to tip. Keep the angle steady. Continue until you feel a slight rough lip, called a burr, along the opposite side of the edge.
- Repeat on the other side until the burr flips back.
- Switch to the fine side and repeat with lighter strokes to polish the edge and remove the burr.
- Rinse, dry and test on paper.
The first time takes half an hour. After a few sessions, it takes ten minutes.
Or let someone else do it
Many kitchen stores, hardware stores and farmers markets have a sharpening service that costs a few dollars per knife. That’s a perfectly good choice once or twice a year. Just keep honing at home in between.
How to keep an edge longer
- Cut on wood or plastic, never glass, stone or ceramic.
- Hand wash and dry immediately. Dishwashers dull edges and loosen handles.
- Store knives on a magnetic strip or in a block, not loose in a drawer.
- Don’t scrape food off the board with the edge. Turn the knife over and use the spine.
The knives and boards are in the kitchen edit, and the guide to which knives to buy is The only three kitchen knives you need.